Re: Netapp ONTAP 8.0.2 - NFS takeover/giveback - should it be visible to...
I think that if I use nfs version 3 and hard mount option on clients they will not see any problems during takeover/giveback. What do you think about
View ArticleRe: Netapp ONTAP 8.0.2 - NFS takeover/giveback - should it be visible to...
I am using nfs over tcp. 2013/7/11 Rafa³ Radecki <radecki.rafal@gmail.com> > I think that if I use nfs version 3 and hard mount option on clients t
View ArticleRe: Netapp ONTAP 8.0.2 - NFS takeover/giveback - should it be visible to...
I've had occasions when I enjoyed using hard nfs mounts. As long as both humans and the software they run are tolerant of possibly lengthy hangs, that
View ArticleRe: Netapp ONTAP 8.0.2 - NFS takeover/giveback - should it be visible to...
On 11/07/2013, at 7:14 PM, Rafa³ Radecki wrote: > I think that if I use nfs version 3 and hard mount option on clients they will not see any problems
View ArticleRe: Netapp ONTAP 8.0.2 - NFS takeover/giveback - should it be visible to...
Thanks for all the info, 'hard' did the job well. Best regards, Rafal Radecki. 2013/7/12 Jeremy Webber <jeremy.webber@al.com.au> > > On 11/07/2013
View ArticleFAS 3210 after upgrade from 8.0.2 to 8.1.3 - higher cache age.
Hi All. I've performed an upgrade and afterwards my cache age is higher. Before the upgrade it was ~3 minutes, now it is ~4.5 minutes. The amount of
View ArticleAD/LDAP Auth
Disclaimer - I'm not Windows savvy so feel free to set me straight if/when/where needed.. I've searched around in the communities site and have read
View Articlethinn volume how to?
Folks, Please tell me if the way to create a volume that will contain thin luns is the best below vol create vol1  -s none aggr0 550g  vol options v
View ArticleRE: AD/LDAP Auth
All you need is to run CIFS setup to allow for the Kerberos/SASL bind to take place against the AD server. You don't need a CIFS license, as 7-Mode al
View ArticleFAS2040 to FAS2220 head swap
Hi all, I have an (empty) single-controller FAS2040 with a DS4243 full of 2TB disks, which is purely used as a SnapVault destination. I need a bit mo
View ArticleHow non-disruptive is ifgrp favor <standby interface>
Happy Friday We're looking to make a change to the production cluster running 300 VM's including Oracle RAC ahead of the weekend full backups (which
View ArticleTested: How non-disruptive is ifgrp favor <standby interface>
I tested this on the standby (snapmirror destination) cluster - interesting findings (This is 8.1.2 7-mode on 3270 BTW) - pre-status (e1a is up and
View ArticleRE: Tested: How non-disruptive is ifgrp favor <standby interface>
If you have spanning tree enabled for ports to which filer is connected it may take at least 30 seconds until port will transition to forwarding state
View ArticleAtaching windows server to netapp
Can you help me with the order of the installation of new windows server software: 1. Install Host Unilties? (Does that enable MPIO) 2. Install netapp
View ArticleRE: Ataching windows server to netapp
Install latest hotfixes (required for windows version) If installing on windows 2008, install MPIO feature (if you are using MPIO) Install driver (if
View ArticleRe: Ataching windows server to netapp
There is a big write up here that list the order the following way, is that correct? http://www.cosonok.com/2013/05/installing-netapp-software-stack-
View ArticleRe: sis start -s causing system slowdown
Hi Chris - What version of DOT? What does a sysstat -x 1 show (CPU and Disk Util wise)? sysstat -x 1 CPU NFS CIFS HTTP Total Net k
View ArticleRe: sis start -s causing system slowdown
DOT version 8.1.2p4 I have done a 'sis stop /myvol', would restarting it again (sis start -s) lose all existing progress, or can I do a normal sis s
View ArticleRe: sis start -s causing system slowdown
"snapmirrors would have been running during this time (3 minute intervals to a DR site)" how many snapmirrors are you running at 3 minute intervals ?
View ArticleRE: EXN3000/DS4243 PSU replacement clearance issues
And if you see that you won't make it, re-insert the broken one. That stops the 2 minutes countdown also... sent from my smartphone, please excuse ty
View Article